Any idea what happened here?
Any idea what happened here?
I was printing PLA, it looks ok up to a certain height (although it was warping slightly), but then it becomes ugly. I will do a test print of the same height, butaybe you already have an idea.
You're viewing a single thread.
7
comments
Looks like a partial clogged nozzle to me.
Just happened to happen at that height. If I'm right it should Start at the bottom on the next print as well.
Cold pull should be the solution.
Thanks, maybe it was just tangled filament 🤔, but I will do a cold pull anyways.
You've viewed 7 comments.