DIY keyboard

Hand-wired, 3D printed case, laser cut switch plate, “laser dye sub” keycaps, custom layout.

Posted this on a couple of communities a while back, but I just subbed here and this board has actually worked really well.

You're viewing a single thread.

18 comments

ooh this is rlly cool!! I think the layout would drive me insane tho xp
- It's not a world apart from what the keyboard world calls a "96%". I made sure no key was wide enough to need additional stabilizing clips, which led to the split space among other changes, but layout-wise it's not too far off from several numpad laptop keyboards I've used over the years. It has been very liveable, and it's on my work computer now.

You've viewed 18 comments.