I buy ParaMax cord (with the core) I only found standard Paracord without core, not the larger ParaMax. Also core-less Paracord seems usually a bit tighter than with a core somehow and that can be an issue with thick cables.
This is 16 awg silicone dual core wire with a gold ParaMax sleeve (bigger than standard Paracord). The connectors are Lemo 2B on the left and Fischer on the right. This cable is to power a 35mm film camera (ARRICAM LT) on a Steadicam (XCS).
They’re custom cables that have to be made to order as they’re all different. Also I use silicone wires which have a high heat resistance and very flexible but any small cut can tear the coating. So it needs to be protected with a sleeve. Plus it’s easier to find your personal calbles on set when they’re color coded (steadicam operators usually come with their own custom power cables for their steadicam but then also use cables from the camera package. And I’ve lost cables when they get mistakenly returned to the rental houses.
A good quality iron with temperature control, tip cleaner, a good copper sponge (no wet sponge), and a copious amount of no clean flux. Also I have switched to silicone wires inside the sleeves because they don’t melt, but they can tear if not protected by a Paracord sleeve. Also, I use a 3rd hand with 4 goose neck and a magic arm with nano clamp. Final tip: practice. It takes a while and a lot of mess ups to get it right.
Remove the core of your Paracord (you need 1.5x of Paracord to wire length about (depending on wire thickness)
Sleeve the Paracord over your wire. That’s the hard part. (My trick has been to solder a length of thick magnet wire to one side of the wire and use it as a needle to guide the wire down the sleeve.
Add all the heat shrinks and connector sleeves you need
This is about the thickest I can fit in a ParaMax sleeve. Bigger than that and I use PET mesh sleeves instead. This cable is used to power a 35mm film camera (ARRICAM LT) on a Steadicam with 24v.
Nice stuff. I sometimes make very high voltage cables (silicone jacket is 5x the actual wire diameter). I'll try your technique next time, though I already know getting the sleeve sliding on silicone is gonna suck. Maybe some soapy water... Hmm.