Shit posting but 3d this time
Shit posting but 3d this time
Print failed because the layer adhesion is shit on my printer.
40 comments
-
If printing PLA, put a brine (salt solution) on your bed. PLA bonds with salt when warmed up (heated bed) and loses its bond when cooled off.
-
Is this legit? Or are you making a spaghetti joke? I actually can't tell lol
-
Here's a scientific paper about it. :) https://medialibrary.uantwerpen.be/oldcontent/container11343/files/bonding_pla_with_salt_water_v20160713.pdf
A brine is a much cleaner solution than the usual advices of hairspray or tape. Just be careful not to put salt on your electronics.
-
Thanks!
-
-
-
40 comments