Cutting board questions
Cutting board questions
So I just picked up this 12"×6"×10' maple beam at an auction today and had to chop off two feet of it to fit it in my car. I'm thinking of making a couple end-grain carving boards for friends with what was cut off.
I'm tentatively thinking of just slicing it into 2" cookies and gluing them together, but I've never seen a cutting board like this that wasn't a collection of like 1" pieces glued together. Is there any reason not to use larger pieces when gluing up a cutting board? Thanks in advance
You're viewing a single thread.
The bigger the wood the more movement it will have. End grain boards like you describe often have their pieces oriented in opposing directions to manage the warping due to expansion and contraction. Plus the more pieces the more glue jointing holding it together.
To provide more stability, you could cut a series of slices and flip every other one such that the curve of the grain is alternating.
Like, instead of one, large 2" slice, two 1" slices, rotated 180° relative to each other?
I think we're saying the same thing?
You have your end grain slab laid on a table in front of you. From left to right divide cut it into parallel pieces (width of these is up to you 2" or 3" is probably fine). With them all laid on the table on their original pattern, rotate or flip alternating slices. Glue it up.