Skip Navigation

Got klipper up and running on the new Ender-3 V3 se

Made sure the stock firmware printed the example gcode that came on the SD card and then immediately embarked on my journey to get klipper running on this guy.

I didn't finish until the wee hours this morning so I've yet to really give it a go but all the essentials are operational.

Here's the GitHub link to the config I created: https://github.com/0xD34D/ender3-v3-se-klipper-config

16

You're viewing a single thread.

16 comments
You've viewed 16 comments.