Skip Navigation

First layer woes - looking for advice

Hi folks, I've had my ender 3 v2 for around 2 years and it's been trouble-free until lately. Recently, I've had major issues with the first layer. I found a few worn components, so I got a dual gear extruder and replaced the nozzle, recald the esteps, bed level and z offset. Nothing I do seems to work.

The issue happens on the first layer when it first starts to extrude. The first 5mm or so of extrusion curls up behind the nozzle, then the extrusion sticks to the bed and it continues normally... Until it needs to starts a new extrusion, then the same thing happens...the curl.

I have to think it's something with temperature, but I haven't changed anything about the filament since these issues started.

Looking for any advice. Thanks!

29

You're viewing a single thread.

29 comments
You've viewed 29 comments.