Is this an acceptable amount of flatness for a new table saw? Sawstop CTS
Is this an acceptable amount of flatness for a new table saw? Sawstop CTS
Discover the magic of the internet at Imgur, a community powered entertainment destination. Lift your spirits with funny jokes, trending memes, entertaining gifs, inspiring stories, viral videos, and so much more from users like cloudane.
Doesn't seem flat enough to me. I've always heard the tablesaw is the flattest surface in your shop. Is this okay?
You're viewing a single thread.
There's no way we can tell from a picture. If you had put a reference on there that was flat so we could see the gaps, or better yet you could measure how big said gaps were with feeler gauges, that we could comment on.
If you don't believe it flat enough, see if SawStop provides a flatness tolerance, and I'd you don't think they meet it deal with them, not Lemmings.
There are feeler gauges in loads of these pictures.
I included some pictures of the fence against my straight edge showing them both being dead flat for reference. Many of the pictures show feeler guages with the thickness.
My mistake, I entirely missed the link.