Rant: Cura did the one thing a slicer shouldn't do
Rant: Cura did the one thing a slicer shouldn't do
Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then..
You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they're apparently not in the ~/.config/cura folder anymore. Nice.
You're viewing a single thread.
Yea I remember switching to prusa slicer because of this and I also seem to get nicer prints aside from seams not being great but I alsp haven't put much effort into trying to fix that. Never lost my settings on prusa.
Yea, planning to give it a try. I just found the settings in
.local/share/curaso that's at least a good thing, but what a headache.