Tips/Tools for sharpening a recurved blade?
Tips/Tools for sharpening a recurved blade?
Hey guys! I've just recently gotten into collecting pocket knives, and I wanna make sure I'm taking proper care of them. My last two purchases have been karambits, both with fairly steep recurved blades, whose edges I'd like to be able to maintain.
I know that normal sharpening stones aren't going to allow me enough contact with the blade to actually put an edge on it, so I've picked up a Smith's DRET sharpener and have been practicing on an old dull knife with a stiletto blade, just to try to get some basics down. I'm getting better with it, but I'm struggling to get an even, consistent edge. Even without any special optics, I can see with my own eyes that I've got wildly uneven angles.
Granted, I'm practicing with a very low-quality knife that was already in pretty rough shape. I've managed to get the edge from "literally unable to break the skin with 20 pounds of pressure and aggressive sawing motions on my forearm" to "can cut through paper with about half of the blade before bunching up", though it's come at a cost of scratching the absolute hell out of the rest of the blade (which is just me being sloppy).
I figure that once I'm able to get competent enough with sharpening a normal blade shape that I'll move on to testing with a donor karambit. I picked up a super cheap, mall-ninja-ass karambit on Amazon because the reviews were all poor and said that the knife arrived completely dull, so I figured this would be perfect to practice sharpening. Unfortunately, it arrived with a surprisingly sharp edge, so I'm gonna have to abuse this knife for a bit before I can even practice anything on it.
Just curious what sort of tools y'all recommend for dealing with recurved blades, or any techniques I could try to incorporate into my practicing. Thanks!
You're viewing a single thread.
It is possible to sharpen a recurve edge on a waterstone with a rounded corner, but having wasted my time learning how I prefer the Sharpmaker. It’s near enough to the same speed, more intuitive, and more difficult for a new sharpener to make a mistake.
Some jigs have rounded stones specifically for recurves; I know there is a Lansky set. I haven’t used one, myself.
I suspect almost all heavy use recurve blades, carpet knives come to mind, are sharpened using pull through sharpeners. There are shaped sharpening stones specifically for recurves historically used in trade work, but they’re going to kind of suck.
Perhaps not a useful avenue for you right now, but my best results on recurves have by far been from paper wheels.
I know you asked how, but if you end up with only a few recurves paying a pro to do it is a reasonable option. Sharpening recurves is a niche inside a niche. No method I’ve tried of doing it by hand feels elegant or “right”.