Clean finish while ironing
Clean finish while ironing
I've been tuning to print at a 0.1mm layer height, the ironing turned out like this. The left side of the Z is a little textured and more shiny.
Why did this happen and how could I fix it?
You're viewing a single thread.
7
comments
Permanently Deleted
Ironing is a 3d printing term where the heated nozzle is used to smooth the final layer, it's not about taking an actual iron to your print.
The print shown is a calibration cube, meant to show you the results of your print settings so you can adjust them to get better prints.
Permanently Deleted
Exactly, it's not about fixing this print, but about figuring out what's going wrong so you know how to make the next one better.
You've viewed 7 comments.