Motherboard swap!
Motherboard swap!
After tuning my vref, the printer was missing steps still. I pulled the trigger and am swapping from the 4.2.2 to the 4.2.7 creality board to see if that resolves the issue.
While i was in there, I figured I’d put another z axis motor on there.
Do you guys have any recommendations on firmware or should I just stick with creality’s?
You're viewing a single thread.
If you're sticking with Marlin, I've been very happy with the "professional" firmware. The configurator is pretty easy to set up if you change any hardware like a new bltouch or new hotend if that's your thing.
Yes, as an alternative to klipper -this really is your end goal - use the firmware by mriscoc, it is really nice and robust.
Gives you more options and the results are better than the stock fw.