One of my favorite 3D printed organizations. Custom silverware drawer
One of my favorite 3D printed organizations. Custom silverware drawer
cross-posted from: https://lemmy.world/post/5265624
I made this about a year ago and it's one of my favorite creations. Even though I made a mistake in measuring the bottom and had to cut out some slots. One day I'll print it again, but it used a ton of filament and took forever last time.
You're viewing a single thread.
78
comments
3D printed stuff is not geat for hygienic reasons because the little groves accumulate dirt over time and is hard to clean. Did you coat the print somehow?
Ehhh I wouldn't use it for putting food directly on but for putting only clean, dry silverware on it's likely fine.
You've viewed 78 comments.