Soap tray test print
Soap tray test print
Printed a simple soap tray- it was just a plate printed vertically- 3mm thick with rounded edges.
Prusaslicer settings were 1.5mm fuzzy skin with 2mm connection points, spiral mode with zero bottom infil, and a 3mm brim for adhesion. (The brim is easy to remove, and the edge looks nicer with with no infill.)
100%extrusion width.
You're viewing a single thread.
8
comments
That's really neat, do you have a link to the STL?
I think the STL is just a rectangle
okay, cool - I'll try it out, thanks!
It is a rectangle, but the trick is to start the print with the nozzle 1mm off the bed to replicate the texture.
You've viewed 8 comments.