I am trying to do something... Special
I am trying to do something... Special
So someday ago I tried to fit in the "Back Mounted Electronic Box By Teaching Tech" On my Ender3 (OG). Only problems..... 1st: The box would not fit (The tolerances on my printer are awful) so I spent 2hrs sanding down the box. 2nd: The printer would not turn on, it took me a day to realize that I wired the cooling fan BACKWARDS.
My objective in this Project is to gain Cable Management on my printer (Which is now far worse than before btw, will try to fix) and I am running Klipper on a [RASPBERRY PI 3B+] (do you see where I am going?)
So I try to reduce the amount of unnecessary cables AND I WAS WONDERING (Since I saw the fact on a Teaching Tech video) if I could connect the raspberry pi power directly From the motherboard (SKR MINI E3 V2.0) to the PI's gpio to power it.
So my question is:
On what ports should I connect the two (+5V and GND) cables ON THE MOTHERBOARD and THE PI'S GPIO.
If you did not understand something feel free to ask me.
Video link: https://youtu.be/yW9ovo9CHi0?t=320
You're viewing a single thread.
One thing that I'll add in is that I started with a similar setup, but I've heard it isn't ideal to be turning your pi on and off all the time without a proper shutdown sequence. I have my printer psu and filament dryer both plugged into smart plugs. Klipper is connected to home assistant wirelessly so I can turn them both off when prints finish, at idle, etc. My printer is in an enclosure, and the psu, pi, and mainboard both sit outside to keep them from getting hot. Pi has its own charger. I don't find it to be a burden to have the pi and psu both plugged into outlets rather than only having one plug. I find it to be a lot more stable for troubleshooting and any power issues that have come up.
Just so you know, I also started off with the teaching tech all in one electronics box. I spent a ton of hours modifying it for my particular sbc and printer. I guess I ran into issues when I would have to take out one of the boards to work on it, lol. The tolerances were really tight and it was just a pain to get it out from behind. I still have the pi+mainboard both in a box, but it's a new one I designed later on that just sits on a shelf below the printer (wires come through a hole). I find it to be really useful for printing ABS and other hot filaments and keeping a clean and tidy enclosure.