It's like everything, practice slowly, get good form wired in, then when you write fast for exams your writing will be worse than normal, but still legible.
Practice writing slowly and with good form. Write regularly, give yourself practice pieces. At uni you will be writing FAST, so it'll get worse if you don't keep disciplined.
Alternatively, learn to touch type, and type any work you need to hand in. - if your handwriting is so bad, you may want to make your notes legible to yourself for revision.
Brilliant, many thanks. With all the old phones in my cupboards I'd hoped this was the answer, but it's good to get a second opinion.
I want to store a battery powered device long term (decades) as a reference article, it will never be switched on or charged again. The problem is that it contains a small LiPo battery that will be very hard to remove.
Is there likely to be any significant risk I need to worry about? Once depleted will the battery be relatively inert?
This is very interesting. Have you considered studying social engineering? - I've found SE techniques quite understandable to help form a process to deal with people in a 'useful' way. Many years ago I was sent on a positive influencing course via work and discovered that most NTs can be quite easily manipulated with a few simple tricks. In the end I stopped using them as it felt unfair.
Butt your enclosure right up against the lock body, then you reduce shearing forces trying to pull it off the door. Extend the pull bar through your enclosure so you still have a manual override.
While I'm not adverse to home automation, is this something you need in your life, or just want? I like my perimeter security too be simple and tight, extra complications make the security audit much harder.
Will your insurance stand up to home made remote control unlocking?
To answer your question, place the servo in a suitably large enclosure and practically any adhesive should work, e.g. 3mM command strips or even velcro or double sided sticky. When confident that this is what you want, use a screw.
I've avoided the conversation entirely. Ever since the pandemic I've done my own hair with clippers. Made a good enough job of it, even if I've sometimes needed to do a small adjustment the next day.
For a simple style it's not that difficult if you take your time.
It's a long time since I had one that age but we clearly noticed when the kids had an upgrade and behaviour changed. I'd put it down to him enjoying his new capabilities and being to excited to sleep. Don't think it's a problem, just roll with it, it's not as if it's a toy you can take away!
Have fun, it doesn't get much easier, but it does get different.
Thought I did so well on my phone. It kept auto correcting code to coffee. Maybe it was telling me something.
Yes, plan for it!
All the other comments are great advice. As an ex chemist who does quite a bit of code I'll add:
Do you want code that works, or code that works?! It's reasonably easy to knock out ugly code that only works once, and that can be just what you need. It takes a little more effort however to make it robust. Think about how it can fail and trap the failures. If you're sharing code with others, this is even more important a people do 'interesting' things.
There's a lot of temporary code that's had a very long life in production, this has technical debt... Is it documented? Is it stable? Is it secure? Ideally it should be
Code examples on the first page of Google tend to work ok, but are not generally secure, e.g doing SQL queries instead of using prepared statements. Doesn't take much extra effort to do it properly and gives you peace of mind. We create sboms for our code now so we can easily check if a component has gained a vulnerability. Doesn't mean our code is good, but it helps. You don't really want to be the person who's code helped let an attacker in.
Any code you write, especially stuff you share will give you a support and maintenance task long term. Pirate for it!
Code sometimes just stops working. - at least I'm my experience. Sacrifice something to the gods and all will be fine.
Finally, you probably know more than you think. You've plenty of experience. Most of the time I can do what I need without e.g. classes, but sometimes I'll intentionally use a technique in a project just to learn it. I can't learn stuff if I don't have a use for it.
I'm still learning, so if I've got any part of the above wrong, please help me out.
Yes prime minister is the most accurate documentary about British politics of all time.
Do you on now anyone who uses disposable vapes? There may be a useful battery in one of those if you can't find an alternative.
There's a lot of Scotland, and don't underestimate driving times. Argyll is good, but can be rather wet any time of the year. Going around now you should be safe from the midgies. Recommend getting onto some of the islands too, and boat rides are always nice. Kerrera is a lovely little island just by Oban. It has a very atmospheric castle, though the teashop isn't as good as it was so pack a lunch. If you like a dram, make a tour of some distilleries, each has it's own character. Argyll has lots of archeology & standing stones if that's your thing. There are loads of lumpy bits of you like walking too. Pretty much anywhere is good, tourist hotspot are ok, but try to get off the beaten track once in a while.
If you're driving, and going onto country roads, please please please learn to reverse.
If you're lucky you may get to spot some wild haggis, but they're quite rare now. The farmed ones are cute but have a nasty bite so be careful.
Also don't neglect the borders, loads of history.
It may not sound your thing, but consider geocaching... It takes you to some interesting out of the way places.
I like a cheap watch, I made my two watches using Ali parts and Seiko movements. They look good enough to me and do their job perfectly. If anything goes wrong it won't break the bank to fix. Imagine scratching a rolex!
3 day working week will more likely mean companies cutting staff by 50%. Can't imagine most people being able to live when only working 3 days.
It's in Dubai, right? Simple solution, turn off the Aircon half way through the meeting just to show them what excessive temperature is like.
Don't let them out until a decision is reached!
Ok, it wouldn't be constructive, but it'd be good to see all the fossil fuel lobbyists sweating, even if just for an hour.
Why wasn't there security on the device? My works devices are password protected and it's a disciplinary offence if I share passwords or give unauthorized access.
If he gave them the login creds, then he should be penalised .
If he logged in and gave the device to non parliamentary staff, he should also be penalised.
He got caught because it cost money, which is the lesser offence. Cyber security should be more robust for ministers than it is for most companies, but seemingly not.
Not sure if this vid will help you, but it's real life experience of carrying for someone who has the disease.
Apparently other people have said it's accurate and helps. I've no connection other than following the creator for his excellent technical content.
Arduino and esp32 are both good places to start. On YouTube look up ralph s bacon I think he is - He does lots of microcontroller stuff, and of course the likes of big clive will teach you all about basic electronic circuits.
If you're a complete newbie, get a kit and work through the tutorials.
Stuff you'll need at first is a microcontroller, prototyping breadboard and a few components (should all come in the kit of you go that route). When you have something that works that you want to keep, you can think about a cheap (ish) soldering station and either veroboard, or look into getting your own boards made.
A multimeter will help a lot (cheapish will do) and depending on how deep you get, a bench power supply and an oscilloscope, but you can live without those for a while.
Get good quality solder, and using extra food quality flux changed the game for me. If you are an older person, magnification really helps too!
Get components in 10's or more as you'll save a little and it doesn't matter much if you let out the magic smoke. For hobby stuff, Alix is your friend.
Have fun.
Do self build watches get the love in here?
This is my second build, I wanted a more relaxed every day watch with good readability as my eyesight is starting to go. I also fancied a bronze case and will let the patina form naturally. Any scratches, marks or dings will, I think, add character.
Inside is a Seiko nh36 to give me some options later if decide I need day/date.
Thought I'd made a mistake with the white hands but now really like them. It's nothing special or expensive but it meets my needs perfectly.
I bought a slate clock as a restoration project but didn't spot at the time that it had been painted black.
Any advice on how to remove the paint without causing damage? Will commercial paint stepper do the job?