Why does this happen and how to prevent it?
Why does this happen and how to prevent it?
This is the only place in the whole print where this happens.
You're viewing a single thread.
16
comments
Have you set up linear advance/pressure advance? I found it worked wonders with making sure the extruder gets back up to pressure after a retraction.
No idea what it is, will check it out, thanks for the pointers!
I like teaching tech's video on it. https://youtu.be/n3yK0lJ8TWM?si=kq1VvgqpiyAx3DAO
Here is an alternative Piped link(s):
https://piped.video/n3yK0lJ8TWM?si=kq1VvgqpiyAx3DAO
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I'm open-source; check me out at GitHub.
You've viewed 16 comments.