Finally got around to trying a .6 nozzle.
Finally got around to trying a .6 nozzle.
I have always wanted to try printing larger, using a bigger nozzle - just got around to swapping to a .6mm in my MK3S+. Printed a gift for a childhood friend. 300% size. Took just under 10 hrs. With the slicer settings on .4mm it was over 17hrs.
You're viewing a single thread.
How did that print so well without any supports?
That is a very good question. There aren't any insane overhangs, just a few tricky spots. I had print he same thing smaller, so I knew it would be okay. I think the file actually mentioned in the notes that you COULD print it without support.
I was shocked too at first, but then i realized the same thing, i don't see anything problematic, what a great model
I had to dig to find where I got the model from. I suppose I should add the link in case anybody wants to give them kudos or print it for themselves.
It was created by Rocket Pig Games: Printables link