Flipping Anycubic Kobra 2 Heat Bed Platform
Flipping Anycubic Kobra 2 Heat Bed Platform
Would this be a good idea? The bottom surface of the printed things would be way more flat. Anyone tested this? Any reason why i shouldnt test it?
The surface is textured so that the parts stick better. If you want a smooth surface, it should be fine to turn it upside down. But you will be a little more likely to have prints come off the bed.
Thx, thought that. But using brim might help, correct?
Somewhat. But it usually prints alright just as is on a smooth bed. The micro texture helps just a bit.
I have printed on the smooth side. At first the prints stuck well. Then the border started releasing. I tried brim but that did not help. Tried a glue stick which worked but it took away from the smooth finish. Tried a very light coating of hairspray and it worked well.