Skip Navigation

Klipper keeps deleting my Z offset instead of saving it

Every time I use calibrate_probe, I get the message "The SAVE_CONFIG command will update the printer config file with the above and restart the printer."

When I click Save Config, it restarts the firmware, and then I get the warning "Option 'z_offset' in section 'bltouch' must be specified."

If I go check my printer.cfg, the [bltouch] section now has z_offset commented out with the old value and I have to remove the comment and copy in the new value.

Am I missing something? What am I doing wrong?

5
5 comments