Skip Navigation

Underextrusion at the start of first layer infill with Cura 5.2.2

Hey fellas!

I'm having an issue with Cura, when printing the first layer the start of the infill is under extruded. The issue is not present with Prusa slicer. Also, in Cura the issue only happens when the nozzle has to move to the infill position without extruding (there is no retraction!!), Cura A in the picture. When the infill starts immediately after the walls there is no problem, Cura B in the picture.

With Prusa Slicer there is no problem even if the nozzle has to move, and in this case there is even retraction. Because of this, I'm thinking that it's a problem with a parameter in Cura, but I don't know which.

Printer is a stock (but not for long...) Ender 3 Neo.

I tried changing flow, line width, retraction settings, increasing initial layer bottom flow, but it's the same. What parameter would affect this?

Cura A preview ; Cura A gcode

Cura B preview ; Cura B gcode

Prusa preview ; Prusa gcode

Image

6
6 comments
You've viewed 6 comments.