Skip Navigation
Deleted
*Permanently Deleted*
  • I was having the same audio delay issues with speech, take-off/landing sounds, etc when I was playing the game installed on an HDD storage array. I moved the install to the SSD system drive and that's all gone away. Crashes have gone down too, I was crashing 2-3 times in an evening of playing but for the past several days or more I might see one crash in a 4+ hour session. Still more crashing than it should but it's not absolutely terrible

  • Deleted
    *Permanently Deleted*
  • I hate the ea launcher with such a burning passion as to outshine the sun. ~80% it causes a problem launching a game for me and provides zero benefits for it's use. It has no consumer friendly reason to exist

  • Help me troubleshoot
  • Thanks I'll give some of these suggestions a try. I am printing with PLA at the same temps I've used in the past with the same material. I wouldn't think the change to pei would require a changing of print temp but I'll keep that in mind as well.

  • Help me troubleshoot

    This print started fine the first handful of layers before I walked away. I came back later and everyone of these blocks was curling up with the corners lifting off the bed. I just put on the PEI plate, this is the first print on it. I did level the print bed manually with a sheet of paper, the first layers of each block looked nice and uniform. I'm printing with the bed at 60c which is what I've always used with the flexible magnetic print mat that came on the printer. Should I be turning down the bed temp with the PEI plate?

    Thanks for any advice

    7
    What is every here printing with?
  • Kingroon KP3S here. Totally stock. No issues with it, always had good quality from it out of the box. I want to add a touch sensor and klipper to it but haven't had the time to figure it out

  • InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)ME
    MeatballFlag @lemmy.sdf.org
    Posts 1
    Comments 11