When your garage is REALLY cold
When your garage is REALLY cold
I could edit the firmware but I like this just in case there are thermocouple issues.
I can also point a heat gun at it for a minute.
13 comments
-
If it is too cold for the equipment, it is too cold for me.
This error is a nice indication for me that I need to turn up the diesel heater before starting the voron.
-
You can check what the value actually would read as if you unplug the thermistor (as that's what it's a protection against), and as long as you aren't near that reducing MINTEMP should be perfectly fine. For example, mine reports something like -50C.
-
I keep a hair dryer next to my enclosure to get it above the MINTEMP threshold, it’s really stupid, but it does at least work.
-
Honestly makes a lot of sense. The ink probably turns into a solid at too low of a temp.
-
This is a 3D Printing sub. We print with 215°C molten plastic. Putting the printer into an enclosure is usually enough to heat itself, even in subzero conditions.
-
-
How cold is the garage?
-
~9C. The MINTEMP is 10C, I think. I heat it to 11C with a heat gun and it works fine.
-
Thanks. This will be useful to know in future 👍😁
-
-
-
Yes, if the reading reaches 0°C the firmware turns off to protect against measurement failures.
There is probably a patch to chamge that temperature.
13 comments