Majora's Mask on a Bambu Labs X1C
Majora's Mask on a Bambu Labs X1C
https://twitter.com/CNC_Kitchen/status/1720374528985973115
Toooons of waste. 2.5/1 waste/print ratio. wow.
timelapse: https://twitter.com/CNC_Kitchen/status/1720410680736489913
You're viewing a single thread.
Aren't you usually supposed to paint the print in models like this?
supposed to
I don't understand this. Who is supposed to do anything in this hobby? If you wanna print in gray and then paint, go for it. If you wanna print in multicolor, go for it.
You know. To avoid the waste. As pictured.
Obviously art is art.
There are other ways of avoiding waste and given that it was Stefan promoting you can bet this is to prove a point about the X1.
They should be purging on infill instead of the poop method
That's why I asked
A good painter will always create a better job but that also requires time and talent that you might not have.