Skip Navigation
Setting up a printer
  • The fact it won't print below 220° makes me think it's a problem with your hotend, and my best guess is that your nozzle is clogged. The higher temperature might be helping the extruder to squeeze a bit of filament around the clog, but not enough.

    Changing the nozzle is quick and easy, and most printers come with a spare or two, so I would give that a shot before diving too deep into diagnostics.

  • US Army speaks out against Trump
  • I'm pretty sure they're saying his followers are a cult, not the Army. His followers will easily take the word of him and his campaign over the Army and Arlington National Cemetery.

  • I've finally done it, a perfect first layer in progress

    One painful firmware update later and the z-offset bug that has plagued me since getting the Neptune 4 Pro is finally resolved and first layers are good again just like that. I just had to share the thrilling end result.

    25
    Playing around with some visual mods, but the terrain is Vanilla

    I found this tiny cherry grove surrounded on all sides by frozen peaks

    10
    InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)AT
    atocci @lemmy.world
    Posts 4
    Comments 380