Recycling 3D Prints and Waste Plastic into Filament (PET & PLA) by Dr D Flo
Recycling 3D Prints and Waste Plastic into Filament (PET & PLA) by Dr D Flo
Holy crap, that's a lot of work to get a roll of filament. That's only economical if your time is worth nothing. Ugh.
You're viewing a single thread.
Someone at McGill university figured out how to recycle wind turbine blades into 3d printer filament. However, a single blade made enough filament that it's length could go to the moon and back. From one blade!
Aren’t wind turbine blades fiberglass? Can fiberglass be printed?
Anything can be printed with enough heat.
See: lava
Post: "My hot end is only reaching earth's mantle. Do I need to reach the surface of the sun to make this work?"
Now I want a Lava Printer
Not to be like that… but… gases would be hard to print, I’m not sure why you’d want to….
Liquids could be interesting, for like, ice sculptures. But at that point you’d be having to extract heat from ambient… drop the build chamber below freezing
Ice printing could work with supercooled water.
Eh. That could work, might be more complicated though.
I’m envisioning a freezer for an enclosure, then heat the water to just above melting. This would allow using essentially-fdm set ups on the printer itself.
Yes. Well they are mixed with an epoxy.
You can find the research online with all the details.
Glass reinforcement material is a common filler, just as much as carbon fiber.