Hmmm, huge burnt up glob of filament that was stuck to the nozzle, came off, cooled and then caused a layer shift?
Just a guess from what I can see.
What is that a bug?… Oh…. The nozzle… Yeah, that’s a new one
Just..... how?!?
Just playing a guessing game here...
The nozzle was probably already loose, for starters. It may have been possible for the nozzle to catch on the print with a blob that was forming from the loose nozzle.
Once the nozzle was stuck to the print, it got ripped off the bed and the movement of the gantry likely caused the print to spin. If a "leg" kept getting caught on something during travel, that would make sense.
After a few dozen moves, presto! Nozzle is unscrewed and is now one with the print.
Unless something in the hotend was actually broken to cause this, it's a perfect example of why nozzles should be tightened at a higher than normal temperature. Loose nozzle == bad time.
Somehow, I can identify myself with that title too much
Weird. What hotend?
mostly out of the box one of these https://kingroon.com/products/official-kingroon-kp5l-3d-printer
Did you perhaps forget to hot tighten the nozzle? That's a crazy failure to have.
I had just put it on hot earlier that day. I must not have tightened it fully I don't have any other explanation.
Wait...did the nozzle crack in to two parts!?
Nope -- right side is blob, left is nozzle
Ah OK, the thread on the nozzle just looked too short and a bit like it was broken at an angle.
